SmartStep V1, V2 or V3 - Installation

In the SmartStep package you’ll find:

• The basics: treadmill (frame, running belt and handle);
• Accessories: iPad holder, cup holder, remote control (incl. CR2025 battery), power cable (2m) and the red safety lanyard with magnet;
• Maintenance & assembly: manual, a small bottle of lubricant and two Allen keys (5mm for the iPad holder and 6mm for belt tension).

The SmartStep is designed for a quick start. You'll be ready to move in under 5 minutes:

1. Stand the treadmill upright (motor side down) and firmly tighten the front footrests;
2. Pull the latch on the right bar out, fold the handle up, and let the latch fall back to lock it;
3. Attach the iPad holder to the panel with the three screws and the 5mm Allen key. Snap the cup holder onto the right side of the handle;
4. Place the magnet from the red safety cord on the yellow mark on the control panel. The belt won’t start without this contact;
5. Plug into the power outlet and set the front on/off switch to 'ON'.

Your SmartStep may look a little different from the one in the manual. No need to worry – we improved the design. On the latest versions the bottom bar has been replaced by a reinforced inner frame and separate support feet. This makes the structure even more stable.

Do you see small iron particles sticking out at the side? That's normal. These guides help keep the treadmill belt running neatly in the centre and prevent it from touching the incline foot. It's a sign your treadmill is properly adjusted.

Because a treadmill draws a lot of power, we advise against using power strips or extension cords. For a safe, direct connection, we also offer longer power cables of 3 and 4 metres.

The SmartStep must always be connected to a grounded (3-pin) outlet. Use only the original power cable and plug it directly into the wall to prevent interference and protect the motor.